Replacing krawler joints with JJs

[mg2000xj]

Im looking to replace the krawler joints on my 3 link in my xj with JJs. I know the krawlers are 14tpi and thats about all I know. I guess I need to figure out the width and shank length. Should I just pull one out and measure or does someone happen to know? There are 3 total and I would like to replace all 3. Not a fan of the krawler joint; cracked one, completely rusted out and tired looking after a little over a year. Im up for other joint recommendations as well.

Can anyone help a joint noob?

[theshocker]

you will need to know the thread size and if they are right or left hand thread. also make sure to get a joint that has the correct size bolt hole, most flex joints come with either 9/16 or 5/10.

[Rockn93yj]

I replaced mine a couple years ago because they kept failing. width was different and I had to fabricate new mounts. I think i also had to replace the control arms as the threads were differnt diameter. some were 1" and some were 3/4" shaft.